Login

WOUGNET on One Percent Club

WOUGNET Office

WOUGNET is located at Plot 55 Kenneth Dale, Off Kira Road, Kamwokya. Directions: After the Kamwokya market as you travel along Kira road, turn off to your left onto Kenneth Dale, (just before the football field and Kira Road Police Station). Once on Kenneth Dale, look out for the WOUGNET sign post on your left towards the end of the road. Click here for a map.

Go to:

Kubere Information Centre Website


Women In Business Website

WOUGNET Gallery

www.flickr.com
This is a badge showing public photos and videos of WOUGNET hosted on Flickr. Click the images to go to the gallery.

HOME arrow Support arrow Tech Tips arrow February 2011: How to dry your mobile phone when it gets wet.
February 2011: How to dry your mobile phone when it gets wet. PDF Print E-mail

Even if a wet cellphone seems dead, there's a chance it can be resuscitated. Just make sure you act fast--the longer the water sits inside, the greater the likelihood it will destroy the phone for good.

The first step: Immediately cut the power by removing the battery. I know it's tempting, but resist the urge to power up your phone to see if it works--just turning it on can short out the circuits. Remove the SIM card as well. Even if your phone turns out to be beyond repair, the SIM should retain a lot of its onboard information, such as the contacts in your phone book.

With the battery safely set aside, you now have one goal--dry your phone, and dry it fast. If you let the moisture evaporate naturally, the chance of corrosion damaging the phone's innards increases. Instead, blow or suck the water out. But don't use a hair dryer--its heat can damage your phone's components. Instead, opt for a can of compressed air, an air compressor set to a low psi or a vacuum cleaner. The idea is to use air to push or pull moisture out through the same channels it entered.

Finally, use a desiccant (a substance that has a high affinity for water and is used as a drying agent) to absorb any leftover moisture. The most convenient choice is uncooked rice. Just leave the phone (and its disconnected battery) submerged in a bowl of grains overnight. If you're worried about rice dust getting inside your phone, you can instead use the packets of silica gel that often come stuffed in the pockets of new clothes. But acting fast is far more important than avoiding a little dust, so don't waste time shopping if you don't already have a drawer full of silica gel.

The most important thing to remember is to avoid heat. That means no hair dryers, ovens, microwaves or extended periods in direct sunlight. While heat will certainly evaporate the moisture, it could also warp components and melt adhesives. Those fragile glues are also why you'll want to avoid using rubbing alcohol. Alcohol is a solvent and can dissolve the internal adhesives. (If you drop your phone in the toilet, it's okay to wipe the outside with alcohol to disinfect it.)

One final, perhaps surprising, note: If your phone gets soaked in salt water, you should flush the whole thing in fresh water before it dries. When salt water evaporates, it leaves crystals that can damage a phone's fragile components. Just be sure to remove the battery before flooding the device.

WOUGNET Comment: A last note, there is indeed debate as to how successful the above steps are and whether or not sometimes it is a matter of luck. Read the full article by Popular Mechanics online as well as the comments to the article for more information.

--
Summarised by the WOUGNET TechSupport Team from an article by Joel Johnson posted on Popular Mechanics.

 
< Prev   Next >